Ladders by Height
16 ft Extension Ladders in Fiberglass and Aluminum, Type II to Type IAA, Two and Three Sections and More
Reach for single-storey eaves and garage roofs, Werner and Louisville series at this size, duty ratings from 225 to 375 pounds, closed lengths and carrying weight.
Single-storey gutters, garage roofs and porch fascia sit within range of 16 ft extension ladders, and Nation Wide Ladder supplies both Werner and Louisville builds in fiberglass and aluminum. We set the fiberglass FE3200, D7100-2, D6200-2 and three-section D6200-3 against the aluminum AE2200, AE3200, AE4200, D1500-2, D1300-2 and D1200-2, so you can weigh rating, rail material and weight at this size before you order.
- Over 50 years serving contractors
- MA, NH, CT, ME, VT & RI
- Weekly Maine deliveries
What 16 ft Extension Ladders Reach Around a Single-Storey Home
Werner’s reach guide puts a 16 ft extension ladder at an average reach of 15 feet, based on a climber of 5 feet 7 inches with 12 inches of vertical reach. Louisville lists 15 feet 11 inches of maximum reach for its 16 ft models on the same basis, and a maximum extended length of 13 feet, because the fly and base overlap once the ladder is raised. Those figures put gutters, soffits and porch roofs on a ranch house or garage in range, which makes the 16 a natural size for low exterior work.
Werner advises choosing an extension ladder 7 to 10 feet longer than the highest point it will rest on or touch, which leaves room for the overlap and for running the rails past a roof edge. OSHA asks for the side rails to extend at least 3 feet above an upper landing when the ladder is used to get onto it, and Werner sets the highest standing level four rungs down from the top. If your support point is a single-storey eave, a 16 fits that rule, while a second-floor gutter calls for one of the taller extension sizes.
Tell us the eave or fascia height you are working to, and our team will check it against the reach figures for each 16 ft model before we quote.
Werner and Louisville 16 ft Extension Ladders Compared
Both makers offer a 16 in fiberglass and in aluminum, and the duty rating is where the choice narrows. On the fiberglass side, the Louisville FE3200 at 16 ft is rated Type IA for 300 pounds, with the MAXLOCK polymer rung lock, a QuickLatch to hold the sections together, and steel swivel shoes. Werner answers with the D6216-2 at Type IA and the D7116-2 at Type IAA for 375 pounds, plus the three-section D6216-3, also Type IA. Fiberglass rails are nonconductive, so these suit electricians and anyone working near service drops.
In aluminum, Louisville offers the 16 in three ratings, the AE2216 at Type IA, the AE3216 at Type I for 250 pounds and the AE4216 at Type II for 225 pounds. Werner mirrors that spread with the D1516-2, D1316-2 and D1216-2, all with 1.75 in D-rungs and spring-loaded rung locks. Louisville lists its aluminum 16 ft models at 27 to 30 pounds against 35 pounds for the fiberglass FE3216, so aluminum is the lighter carry where power lines are not a concern.
Over 50 years of supplying contractors and homeowners has shown us that the duty rating matters more than the badge, so we match the 16 to the load first.
Carrying and Storing 16 ft Extension Ladders on a Pickup or Van
A short extension ladder earns its place by how easily it travels. Louisville builds its 16 ft models from two 8 foot sections and gives a closed height of about 100 to 101.5 in, a length that suits a pickup rack or a hook on a garage wall. Werner’s D6216-3 splits the same size into three sections, which shortens the closed ladder further for a van interior or a tight storeroom. On the Werner D-series the base and fly separate for use on their own, and the base of the D6200-3 can also serve as a single ladder.
Weight follows the rating. A Type II AE4216 is the easier lift for occasional use, while a Type IAA D7116-2 is rated to carry a heavier climber and tool load. If you fit a leveler for sloped ground or a stabilizer for gutter work, the overall weight rises again, so it pays to choose the rating you will actually load rather than the heaviest on offer. Louisville’s FE3200 description also lists a rope and pulley for raising the fly, a detail worth checking on any 16 ft fiberglass model.
We also install truck racks and van roof racks, so we can size the rack and the 16 ft extension ladder together for the vehicle it will ride on.
Where 16 ft Ladders Sit in the Wider Height Range
The 16 is the entry point of the extension range, and many crews pair it with a 6 or 8 ft step ladder for interior work and a 24 or 28 ft extension for the second storey. Our ladders by height section sets every extension and step size side by side, and you can open the Werner 16 ft range or the Louisville 16 ft range for the detail on each series. Louisville lists a stabilizer and levelers among the accessories for its fiberglass extension ladders, and Werner offers levelers for its own, which helps where shorter extension ladders stand on uneven garden beds.
If staging, racks or fall protection from other makers are also on your list, you can browse them in our ladder and truck equipment brands hub.
Quotes on 16 ft Extension Ladders for New England Homes and Crews
Low exterior work rewards a ladder that is light, short when closed and rated for the real load, and that is the balance we look for when we quote 16 ft extension ladders across both brands. Call 603-434-6911 or 508-754-3030 with your eave height, and we can start from the fiberglass Werner D6200-2 series if you work near power.
16 Ft Extension Ladders FAQs
How high can I reach with a 16 ft extension ladder?
Werner gives an average reach of 15 feet for its 16 ft size and Louisville gives 15 feet 11 inches, both assuming a climber of 5 feet 7 inches with 12 inches of reach.
Which 16 ft extension ladders are nonconductive?
The fiberglass models, which are the Louisville FE3216 and the Werner D7116-2, D6216-2 and D6216-3.
What duty ratings come in a 16 ft size?
Type II at 225 pounds, Type I at 250, Type IA at 300 and, from Werner's D7100-2, Type IAA at 375.
How long is a 16 ft extension ladder when closed?
Louisville builds its 16 ft models from two 8 foot sections and lists a closed height of about 100 to 101.5 in.
Is there a three-section 16 ft extension ladder?
Yes. The Werner D6216-3 is a three-section Type IA fiberglass model, and its base can be used as a single ladder.
Need help choosing the right ladder equipment?
Talk to the team or send us your list and we will put a quote together.







