Ladders by Height

40 ft Extension Ladders for Three-Storey Work in Fiberglass and Aluminum, Type II to Type IAA and More

Reach for three-storey eaves and tall commercial walls, the ten series at this length, duty ratings, weights from 78 to 93 pounds and safe setup.

Three-storey eaves, mill buildings and tall church gables are the jobs 40 ft extension ladders are made for, and Nation Wide Ladder quotes the Werner and Louisville models made at this length. At this length we compare the fiberglass FE3200, D6200-2 and D7100-2 with the aluminum AE2200, AE3200, AE4200, D500-2, D1200-2, D1300-2 and D1500-2, weighing reach, rating and weight so the ladder suits the job.

NH603-434-6911MA508-754-3030

  • Over 50 years serving contractors
  • MA, NH, CT, ME, VT & RI
  • Weekly Maine deliveries

How Far 40 ft Extension Ladders Reach on Three-Storey Buildings

The 40 is the top size in nearly every Werner and Louisville series we compare, and it is bought for the highest work a ladder should do. Werner’s reach guide gives a 40 ft extension ladder an average reach of 37 feet, and Louisville lists 37 feet 3 inches of maximum reach for its 40 ft models, each based on a 5 foot 7 inch climber with 12 inches of reach. Louisville builds them from two 20 foot sections and gives a maximum extended length of 35 feet.

Those figures suit three-storey eaves, the upper walls of apartment blocks and mill buildings, high church gables and tall commercial signs. Because so much length goes into the overlap, a 40 gains only 3 feet of reach over a 36 on Werner’s chart, so measure the real support point before choosing between them. Werner’s advice to buy an extension ladder 7 to 10 feet longer than the highest point it touches still applies at this size, and so does its top standing level, four rungs down from the top. Where the ladder is used to step onto a roof, OSHA calls for the rails to extend at least 3 feet past the landing.

Our showrooms in Windham and Worcester give free in-person consultations, so you can talk through a 40 and its alternatives with us before you commit to one.

Louisville FE3200 Series – Type IA Fiberglass Extension Ladder

Werner and Louisville Series Offered as 40 ft Extension Models

Ten series of extension ladders reach 40, four from Louisville and six from Werner. In fiberglass, the Werner D7140-2 is rated Type IAA for 375 pounds and is the only Type IAA 40 from either maker, while the Werner D6240-2 and Louisville FE3240 are both Type IA for 300. Fiberglass is the choice where a long ladder could swing near overhead lines, since the rails are nonconductive. Louisville pairs the MAXLOCK rung lock on its FE3240 extension with a QuickLatch that holds the fly and base together for climbing and transport.

In aluminum, Louisville offers the AE2240 at Type IA, the AE3240 at Type I for 250 pounds and the AE4240 at Type II for 225, which returns at this length after skipping the 36. Werner lines up the D1540-2, D1340-2 and D1240-2 at the same three ratings, plus the D540-2, an aluminum model rated Type IA at this size. Werner’s D500-2 series also runs past 40 to 44 and 48 ft extension sizes, both Type IA, for the rare job that needs more.

Send us your list and we will quote each 40 by series and rating, so you can compare the options side by side on paper.

Werner D500-2 Series – Type IAA/IA Aluminum Extension Ladder

Weight, Closed Length and Setup for 40 ft Ladders

The 40 is heavy and long even closed. Louisville lists 78 pounds for the AE4240, 80 for the AE3240, 86 for the AE2240 and 93 for the fiberglass FE3240, with a closed height of about 244 to 247.8 inches depending on the model. With ladders this size, plan the carry, the raise and the route around trees and wires before the ladder leaves the truck, and choose a rack sized for that closed length. Louisville lists 40 rungs on its 40 ft models, so the climb to the top standing level is a long one, and a lighter tool load makes it easier on the crew.

At this length a firm, level base and secure footing at the top matter more than at any other size. Levelers handle sloped ground, Louisville’s swivel safety shoes on the FE3200 and AE4200 work tread down or as spikes in soft ground, and a stabilizer spreads the top load across a wall. Werner’s D-series bases separate from the fly, so the lower half of a 40 can do lighter work as a single ladder on the same site.

Our own trucks deliver door to door across New England, and our weekly runs to Maine from New Hampshire bring a 40 ft extension north without a special trip.

Louisville AE4200 Series – Type II Aluminum Extension Ladder

When 40 ft Ladders Work Alongside Staging and Fall Protection

At the top of the extension range, many jobs combine the ladder with pump jack staging, planks and a harness system for the climber. Our overview of ladders by height sets the 40 against every shorter size, and the Werner 40 ft extensions and Louisville 40 ft extensions show each series in detail.

Staging systems, harnesses and racks from the other manufacturers we supply can be compared in our ladder and truck equipment brands hub.

Louisville AE2200 Series – Type IA Aluminum Extension Ladder

Ordering 40 ft Extension Ladders for the Highest Exterior Work

The tallest sizes carry the most weight and the least margin for a wrong guess, so we compare reach, rating and setup with you before we quote 40 ft extension ladders. Over 50 years of supplying contractors has made that kind of check routine for us, and the aluminum Werner D500-2 series covers jobs that need 44 or 48 ft as well.

40 Ft Extension Ladders FAQs

What is the reach of a 40 ft extension ladder?

Werner gives an average reach of 37 feet and Louisville a maximum reach of 37 feet 3 inches, both for a 5 foot 7 inch climber with 12 inches of reach.

Which 40 ft extension ladders are rated Type IAA?

The fiberglass Werner D7140-2 is rated Type IAA for 375 pounds. The other 40 ft models run from Type II to Type IA.

How heavy is a Louisville 40 ft model?

Louisville lists 78 to 86 pounds for its aluminum 40 ft models and 93 pounds for the fiberglass FE3240.

Are there extension ladders longer than 40 ft?

Yes, the Werner D500-2 aluminum series also comes in 44 and 48 ft sizes, rated Type IA.

Is the Louisville AE4200 offered at 40 ft?

Yes. The Type II AE4240 is listed at 40 ft, although the AE4200 series skips the 36 ft size in our store.

Need help choosing the right ladder equipment?

Talk to the team or send us your list and we will put a quote together.

TOP
Nation Wide Ladder

Nation Wide Ladder