Ladders by Height

32 ft Extension Ladders for High Gables in Aluminum, Fiberglass, Aerolite and Three-Section Builds and More

Reach for tall gables and two-storey commercial fascia, the Werner options that end at this size, Type II to IAA ratings, weight, closed length and racking.

Tall gables, walk-out lots and two-storey shopfronts are where 32 ft extension ladders come into their own, and Nation Wide Ladder offers both Werner and Louisville at this size. This is the longest size for the Werner Aerolite B7100-2 and B7100-2X, the three-section D6200-3 and the Type IAA D500-2, and we compare them with the AE2200, AE3200, AE4200, FE3200, D1200-2, D1300-2, D1500-2, D6200-2 and D7100-2 at the same height.

NH603-434-6911MA508-754-3030

  • Over 50 years serving contractors
  • MA, NH, CT, ME, VT & RI
  • Weekly Maine deliveries

Where 32 ft Extension Ladders Reach on Tall Gables and Walk-Out Lots

Werner’s reach guide gives a 32 ft extension ladder an average reach of 31 feet, and Louisville lists 31 feet 5 inches of maximum reach for its 32 ft models, both for a climber of 5 feet 7 inches with 12 inches of reach. Louisville builds its 32s from two 16 foot sections and gives a maximum extended length of 29 feet. That puts the upper gable of a colonial or Victorian, a two-storey house standing above a walk-out basement and the fascia of a two-storey shop or office in range.

The deciding measurement is the highest point the ladder will rest against, whether that is a gutter, a gable wall or the edge of a flat roof. Werner advises adding 7 to 10 feet to that point to cover the overlap and any run past a roof line, and OSHA asks for the rails to extend at least 3 feet past an upper landing. Werner’s top standing level stays at four rungs down from the top, so on a high gable that limit decides the size as much as the wall does. If the measured height lands at the top of the 32 range, the 36 is the safer size. For a single-storey building, by contrast, a 32 is more extension than the job needs, and a shorter size is quicker to raise and set.

Bring the measurement to either showroom on a Saturday morning, when both locations open, and we can talk through whether a 32 or a 36 suits it.

Louisville FE3200 Series – Type IA Fiberglass Extension Ladder

32 ft Is the Largest Size for Aerolite, Three-Section and IAA Aluminum Ladders

Several Werner options stop at this height, which makes the 32 a deciding size. The Aerolite B7132-2 is the longest Aerolite we list, rated Type IAA and described by Werner as 25 percent lighter than a standard 375 pound ladder, with CL and X versions adding a V-rung, leveler system or factory cable hook for strands and poles up to 10 inches. The three-section D6232-3 also tops out here, as does the Type IAA rating on the aluminum D500-2 series, since Werner rates the D536-2 and longer at 300 pounds.

Beside those, both makers offer the usual spread at 32. In aluminum, Louisville’s AE4232, AE3232 and AE2232 run from Type II to Type IA, matched by Werner’s D1232-2, D1332-2 and D1532-2. In fiberglass, Louisville offers the Type IA FE3232, and Werner the Type IA D6232-2 and Type IAA D7132-2. If you want a lightweight Type IAA fiberglass extension or a compact three-section build, 32 ft extension ladders are as long as those options go.

Our team checks the series, rating and fitted options against the job when we quote, so a 32 ft extension arrives set up for the work it will do.

Werner D500-2 Series – Type IAA/IA Aluminum Extension Ladder

Moving and Racking 32 ft Extension Ladders Between Jobs

Length and weight both climb at 32. Louisville lists a closed height of about 196 to 197.5 inches for its 32 ft extension models, and weights of 58 pounds for the AE4232, 60 for the AE3232, 63 for the AE2232 and 70 for the fiberglass FE3232. An extension that long needs a rack built to carry it, and the overhang behind a pickup or van is worth checking before the first trip. The three-section D6232-3 closes shorter, which helps crews who carry inside a van or store ladders in a tight shop.

On uneven ground beside a foundation, a leveler or a leveler-equipped Aerolite such as the B7132-2CL keeps the base square, and Louisville’s swivel safety shoes on the FE3200 and AE4200 work tread down on hard ground or in the spike position on soft ground. Werner’s D-series bases separate from the fly, so the bottom section of a 32 ft extension can also work on its own as a single ladder.

We install ladder racks on trucks and vans, so the rack and the 32 can be sized together for the vehicle that carries them.

Louisville AE4200 Series – Type II Aluminum Extension Ladder

32 ft Ladders With Levelers, Standoffs and Staging

High gable work often brings a stabilizer to hold the ladder off the wall, ladder jacks and planks for siding, and a pair of matching 32s to hang them from. Every size we compare across Werner and Louisville is listed in our ladders by height pages, and the Werner 32 ft models and Louisville 32 ft models break each series down further.

For pump jack scaffolding, planks and fall protection from the other makers we carry, have a look at our ladder and truck equipment brands hub.

Werner B7100-2 Series – Type IAA Aerolite Fiberglass Extension Ladder

Pricing 32 ft Extension Ladders for High Gables and Roof Edges

Several lightweight and compact options end at this length, so the decision deserves a careful look at weight, rack length and rating, and those trade-offs are easier to settle in conversation. Call 603-434-6911 or 508-754-3030 and we will quote 32 ft extension ladders from Werner and Louisville for the gable you measured, including the fiberglass Louisville FE3200 series at Type IA.

32 Ft Extension Ladders FAQs

What height can a 32 ft extension ladder reach?

Werner gives an average reach of 31 feet and Louisville a maximum reach of 31 feet 5 inches, both for a 5 foot 7 inch climber with 12 inches of reach.

Is 32 ft the longest Werner Aerolite?

Yes, the Aerolite B7100-2 and B7100-2X series we list run up to 32 ft.

Can I get an aluminum 32 ft model rated Type IAA?

Yes, the Werner D532-2 is rated Type IAA for 375 pounds. Longer D500-2 models are rated Type IA.

How heavy are Louisville 32 ft extension ladders?

Louisville lists 58 to 63 pounds for its aluminum 32 ft models and 70 pounds for the fiberglass FE3232.

Which 32 ft ladder closes the shortest?

The Werner D6232-3 splits into three sections, so it closes shorter than a two-section ladder of the same size.

Need help choosing the right ladder equipment?

Talk to the team or send us your list and we will put a quote together.

TOP
Nation Wide Ladder

Nation Wide Ladder