Best Sellers
Staging Planks in Aluminum, Extendable and Laminated Wood Designs, With Guardrails, End Rails, Safety Nets and More
One and two person aluminum stages, telescoping planks for ladders and trestles, laminated wood boards, guardrail and end rail kits, and debris and fall nets, compared on width, length, load and OSHA platform rules.
Staging planks carry the crew and its material between ladders, jacks and scaffold frames, so each plank has to suit the span, the load and the edge protection the height demands, and Nation Wide Ladder quotes the Werner, Louisville and Alum-A-Pole staging contractors order most with that whole setup in mind. Our range covers one person and two person aluminum stages, extendable aluminum planks, OSHA laminated wood planks, guardrail and end rail systems, and safety nets.
- Over 50 years serving contractors
- MA, NH, CT, ME, VT & RI
- Weekly Maine deliveries
Shop Staging Planks by Type
Aluminum Staging Planks Rated for One Worker or Two
Most staging planks on a siding or painting job are aluminum stages, flat decks with side rails and rungs that span from one support to the next. Werner and Louisville both build them in two load classes. A one person stage carries 250 pounds, while a two person stage carries 500 pounds, which leaves room for a second worker or a stack of material. The Werner stages we list come in 12, 14 and 20 inch widths, with one person staging at 16, 20 and 24 feet and two person staging from 8 feet up to 32 feet. Louisville covers the same three widths, with one person staging planks from 12 to 24 feet and two person models from 12 to 32 feet.
Width follows the support. OSHA sets 18 inches as the general minimum for a scaffold platform and allows 12 inches on ladder jack, roof bracket and pump jack scaffolds. Alum-A-Pole builds its own staging for pump jack work, and the Alum-A-Pole stages we carry are 14 inches wide in 16, 20 and 24 foot lengths, rated for two people and 500 pounds, with open-hole decking and square rungs. Werner and Louisville staging planks suit crews moving between jacks, trestles and frames, and the Alum-A-Pole line suits crews already running that maker’s pump jacks.
Our team checks the span, width and load rating before we quote, so the staging on your order suits the supports you already own.
Extendable and Laminated Wood Staging Planks for Shorter Spans
Extendable staging planks telescope to fit the gap, which suits interior work between step ladders or trestles where a fixed stage would be too long. The Werner PA200 series locks in 12 inch increments, uses 2 inch deep box section extrusions with riveted cross members, and has positive stops so it cannot over-extend. Werner rates it at 250 pounds and lists the PA206 at 6 to 9 feet, the PA208 at 8 to 13 feet and the PA210 at 10 to 17 feet, for use with step ladders, trestle ladders and ladder jacks. Louisville’s LP-2921 series answers with heavy wall aluminum tubing, a skid-resistant surface and the same 250 pound rating, in 6 to 9, 8 to 13 and 10 to 16 foot models that slide to half their extended length for storage.
Some crews prefer wood staging. The NWWLP-16 laminated OSHA plank is 16 feet long and 9.5 inches wide, built from layers of Norwegian Spruce veneer that spread out knots and other natural defects, and every board is proof-load tested at the plant. The listing states it exceeds OSHA, CSA and ANSI standards. One board is narrower than either OSHA minimum, so laminated staging planks go down side by side to form the deck, and each end still extends at least 6 inches past the centerline of its support unless it is cleated or hooked.
Our Windham, NH and Worcester, MA showrooms offer free consultations, where you can compare telescoping and wood staging in person before ordering.
Guardrails, End Rails and Safety Nets Around Staging Planks
OSHA requires protection for anyone on a scaffold more than 10 feet above a lower level, and it calls for toeboards, screens, guardrails or debris nets where tools could fall on people underneath. Accessories fitted to staging planks answer both rules. The Werner guardrail system builds from SSP-47 post assemblies and 9 or 13 foot SGR guardrails, with STB toe boards and ERT end rail kits as options. Werner packages it in single side kits for 16 to 32 foot runs, and the 24 foot kit holds five posts, four 9 foot rails and two 13 foot rails. End rail kits come narrow for 12 to 14 inch stages or wide for 20 inch stages, and each run kit also comes in a version with matching 9 and 13 foot toe boards. Acro’s 10140 end guard rail system closes the open end of a run as well.
Safety nets hang along the staging. The safety nets we list are 22 feet long for stages up to 24 feet, in three versions. The Werner PJ-SN is debris and man rated and meets OSHA requirements as fall protection, the Alum-A-Pole Simms net is rated for fall protection and debris with Alum-A-Pole planks only, and the orange NWPJ-SN is rated for debris. Matching each net to the staging planks it hangs from keeps that rating valid.
Our own trucks deliver door to door across New England, so posts, rails, nets and long staging arrive together at the job.
Staging Planks Across Jack, Trestle and Pump Systems
A plank is only as useful as what holds it. Ladder jacks hang staging planks from two extension ladders on lower walls, trestles and step ladders carry extendable planks indoors, and pump jacks raise aluminum staging up a pole for taller siding work, where our Alum-A-Pole stages and end rails page sets out that maker’s linked system.
To weigh the ladder, scaffold and rack makers behind each of those supports, browse our ladder and staging equipment brands hub.
Staging Planks Quoted With the Supports and Rails They Need
Siding, painting and roofing crews have bought from Nation Wide Ladder for over 50 years, and our Windham, New Hampshire and Worcester, Massachusetts showrooms deliver to job sites in Connecticut, Rhode Island, Massachusetts, New Hampshire, Vermont and Maine. We quote staging planks by span, width and load rating, with the guardrails, end rails and nets the height calls for, and our best sellers list shows the ladders and truck boxes crews pair with them. Send your wall lengths and support type to 603-434-6911 or 508-754-3030, and we return a quote that lists every stage, plank and rail.
Staging Planks FAQs
What load ratings do aluminum staging planks carry?
Both Werner and Louisville offer a 250 pound one person class and a 500 pound two person class. The Alum-A-Pole stages we list are two person, 500 pound models.
How wide should staging planks be?
OSHA sets 18 inches as the general minimum for a scaffold platform and 12 inches for ladder jack, roof bracket and pump jack scaffolds. Werner and Louisville stages come 12, 14 or 20 inches wide.
Which extendable staging planks fit between step ladders?
The Werner PA200 series and the Louisville LP-2921 series, both rated at 250 pounds. The longest models extend to 17 feet on the Werner PA210 and 16 feet on the Louisville LP-2921-16A.
Are laminated wood staging planks OSHA compliant?
Our listing for the NWWLP-16 laminated plank states it exceeds OSHA, CSA and ANSI standards, and every board is proof-load tested at the plant.
When do staging planks need guardrails?
Once a worker stands more than 10 feet above a lower level, OSHA requires fall protection on the scaffold. The Werner guardrail system and its end rail kits fit stages for that purpose.
How long are safety nets for staging?
The nets we list are 22 feet long and suit stages up to 24 feet. The Werner PJ-SN is man rated, while the orange NWPJ-SN is rated for debris.
Need help choosing the right ladder or truck equipment?
Talk to the team or send us your list and we will put a quote together.






