Ladders
Single and Manhole Ladders in Fiberglass and Aluminum, Fixed-Length Straight Models, Narrow Vault Designs and More
Fixed-length straight ladders for docks, pits and mezzanines, narrow vault models with rim protection, Type IA and Type IAA ratings, OSHA landing rules, and the Werner and Louisville single models we list.
Ordering single and manhole ladders leaves no adjustment to fall back on, so the length, rail material and rating all have to be right before the ladder reaches a landing, a pit or a vault. Nation Wide Ladder sizes them with you, covering fiberglass and aluminum single straight ladders from Werner and Louisville and the narrow Werner M7100-1 and Louisville FE8900 manhole models built for utility access.
- Over 50 years serving contractors
- MA, NH, CT, ME, VT & RI
- Weekly Maine deliveries
What Separates a Single Straight Ladder From a Manhole Model
A single ladder is one fixed length of rails and rungs, with no fly section, rope or rung locks, and it rests against a wall, a beam or the lip of an opening because it cannot stand by itself. With nothing to slide, a single ladder is quick to set and simple to inspect, which suits loading docks, mezzanines, scaffold access, trench and pit entry, and other spots a crew returns to at one fixed height. On Werner’s separable extension models, the base section doubles as a single straight ladder.
A manhole ladder is a single ladder narrowed and toughened for vaults. Openings are tight, the rim chews on rails and the climber has to haul the ladder up out of the hole when the job is done, so manhole models add rim protection and feet that grip from either side. OSHA still sets a minimum of 11.5 inches between the rails of any portable ladder, and a manhole frame stays narrow while meeting it. Utility, water, sewer, telecom and municipal crews are the usual manhole buyers, and our ladder best sellers show where both fit among extension and step models.
With over 50 years behind us supplying contractors and homeowners, we start every single or manhole quote by asking where the ladder will stand and what runs nearby.
Werner and Louisville Single and Manhole Models by Rail, Rating and Width
In single straight ladders, the Werner D6200-1 is fiberglass at Type IA and 300 pounds, with twist-proof rung joints, 1.63 inch D-rungs and lengths from 8 to 20 feet, while the aluminum Werner D500-1 steps up to a Type IAA, 375 pound rating for heavy use away from power. Louisville’s FE3100 is the fiberglass single at Type IA in 8 to 16 feet, and the aluminum AE2100 is also Type IA with lengths up to 20 feet. A 16 foot FE3116 weighs 36 pounds against 33 for the aluminum AE2116, and Louisville marks the AE2100 unsafe around electricity and the fiberglass single safe.
In manhole models, Werner builds the M7100-1 12.38 inches wide between the rails, rates it Type IAA for 375 pounds and offers 8, 10, 12 and 16 foot lengths, with a 3 foot plastic sleeve for the rim and vinyl-coated end caps for lifting out. The Louisville FE8900 is a fiberglass manhole ladder, also Type IAA, about 14 inches wide in 8 to 16 feet, with 3 foot rail protectors on both sides and boots that turn through 180 degrees. Both makers’ single ranges sit in our Werner single and manhole ladders and Louisville single and manhole range.
We run regular weekly deliveries from New Hampshire to Maine, putting replacement single and manhole ladders in front of crews there on a set schedule.
Sizing a Single or Manhole Ladder for Landings, Pits and Street Vaults
With no extension to adjust, measure first. OSHA asks for 3 feet of rail above any landing a single ladder serves, and when a vault or pit rules that out, the top must be tied to something rigid with a grab device for the climber to hold. Lean the ladder so its foot sits roughly a quarter of its working length from the support. A 16 foot Louisville single reaches about 18 feet 10 inches, and Cal/OSHA sets 30 feet as the longest allowed single ladder, so every single and manhole length we list sits well inside that limit.
Street manhole work brings traffic and water. Any ladder that passing traffic could bump must be secured or barricaded under OSHA rules, and climbers may not carry loads that could throw them off balance, so tools go down the vault on a rope. Where cables share the space, OSHA calls for nonconductive rails, and Cal/OSHA cautions that a wet ladder can conduct electricity. A cracked rail retires a single or manhole ladder, since neither maker recommends repairs.
Send us your landing heights and vault depths as a list, or call 603-434-6911 or 508-754-3030, and we will quote each single or manhole length to match.
Single and Manhole Ladders in a Utility Access Kit
A manhole ladder rides on the truck beside retrieval gear, harnesses, gas detection and traffic cones, while a single straight ladder often stays put at a pit or mezzanine until the project wraps. Both ladders have to be carried and secured between sites, which brings racks and boxes from other makers into the same order.
To line up the vehicle side, you can compare racks and boxes from each manufacturer in our ladder and truck equipment brands hub.
Single and Manhole Ladders Quoted by Length and Rating
Nation Wide Ladder quotes single and manhole ladders from our Windham, New Hampshire and Worcester, Massachusetts showrooms, where free in-person consultations let a utility crew handle a vault model before ordering a set. Delivery on our own trucks reaches Connecticut, Rhode Island, Vermont and Maine as well, and we ship anywhere in the US.
Single and Manhole Ladders FAQs
What is the difference between single ladders and manhole ladders?
A single ladder is one fixed straight section for walls, docks and landings. A manhole ladder is a narrow single ladder with rim protection and feet built for vault entry.
Which single ladders suit work near electrical equipment?
The fiberglass Werner D6200-1 and Louisville FE3100. Louisville marks its aluminum AE2100 single unsafe around electricity.
How wide are your manhole ladders?
About 14 inches on the Louisville FE8900 and 12.38 inches between the rails on the Werner M7100-1, so each clears OSHA's 11.5 inch minimum.
What rating do single and manhole ladders carry?
The Werner D500-1, Werner M7100-1 and Louisville FE8900 are Type IAA at 375 pounds, and the Werner D6200-1, Louisville FE3100 and AE2100 are Type IA at 300 pounds.
What if a manhole ladder cannot extend 3 feet past the opening?
Then OSHA permits tying the top to a rigid support, as long as a grab device is in place for the climber getting on and off.
Need help choosing the right ladder or truck equipment?
Talk to the team or send us your list and we will put a quote together.







