Fiberglass Extension Ladders

28 ft Fiberglass Extension Ladders for Roof Access With Aerolite, Leveler and Cable Hook Options and More

Rails that clear a two-storey eave by 3 ft, 27 ft of average reach, fiberglass weights from 50.1 to 74.5 pounds, closed lengths near 14 feet and leveler choices for sloped ground.

Roofers, chimney sweeps and electricians stepping off at a two-storey eave beside a service mast often need 28 ft fiberglass extension ladders. Nation Wide Ladder compares the Werner and Louisville options so the ladder clears the roof and suits the load. At 28 ft we weigh the Louisville FE3228 against the Werner D6228-2, three-section D6228-3 and Type IAA D7128-2. Werner's Aerolite adds the B7128-2, the leveler-equipped B7128-2CL and the cable hook B7128-2X models.

NH603-434-6911MA508-754-3030

  • Over 50 years serving contractors
  • MA, NH, CT, ME, VT & RI
  • Weekly Maine deliveries

Stepping Onto a Roof From 28 ft Fiberglass Rails Near the Service Mast

A 28 earns its place when the climber leaves the ladder at the eave. OSHA requires the side rails to extend at least 3 feet above an upper landing, and Werner advises an extension 7 to 10 feet longer than the highest support point to allow for that run and the section overlap. Werner’s chart gives a 28 ft extension an average reach of 27 feet, and Louisville lists 27 feet 7 inches of maximum reach for the FE3228, both for a 5 foot 7 inch climber with 12 inches of reach.

Louisville builds its 28 from two 14 foot sections with a maximum extended length of 25 feet, and Werner gives the D6228-2 and three-section D6228-3 the same 25 foot working height. The 28 suits two-storey eaves, chimney flashing and gable vents. Where the service mast rises through the roof, a 28 ft fiberglass extension keeps a nonconductive rail beside it, which is what OSHA wants near exposed energized equipment. If the eave sits near the top of those figures, size up to a 32 rather than standing too high.

Bring the eave height and roof pitch to our Windham or Worcester showroom for a free consultation, and we will check the 3 foot clearance with you.

Louisville FE3200 Series – Type IA Fiberglass Extension Ladder

How Much a 28 ft Fiberglass Extension Weighs, and Who Carries It

Weight is the first thing a crew notices on a 28. Werner lists the Aerolite B7128-2 at 50.1 pounds, Louisville gives the FE3228 58 pounds, and Werner puts the D6228-2 at 59.5, the D7128-2 at 67 and the three-section D6228-3 at 74.5. The Aerolite saves close to 17 pounds against the D7128-2 at the same Type IAA rating, which Werner credits to its BOXLOK box rails.

Closed length follows. Louisville gives 173.5 inches for the FE3228 and Werner 168 inches for its two-section 28s, while the three-section D6228-3 closes to 11 feet 4 inches, a shorter load for a van but the heaviest to lift. Louisville lists the Ladder Lash and a side mounted double pulley system for the FE3228, which help secure it in transit and raise the fly. On a heavy 28, two people raising it is common sense, and the Werner D6200-2 and D7100-2 bases separate from the fly to serve as single ladders when the roof work is done.

We install ladder racks on trucks and vans, so a 28 that weighs more than 60 pounds can ride on a rack fitted to carry it.

Werner D6200-2 Series – Type IA Fiberglass Extension Ladder

Ratings, Levelers and Utility Builds on 28 ft Fiberglass Extension Models

Roof work from a 28 tends to load the rungs with flashing, tools and the climber at once. The FE3228, D6228-2 and D6228-3 share Type IA at 300 pounds, while the Werner D7128-2 and the Aerolite B7128-2 step up to Type IAA at 375 pounds. The D7128-2 also comes pre-pierced to accept a V-rung and cable hooks.

Tall ladders magnify any tilt at the foot, so leveling matters on a 28. The B7128-2CL adds a V-rung and leveler system to the Aerolite. For utility crews, the B7128-2X9085 carries a cable hook and V-rung for strand work and poles of up to 10 inches, and the B7128-2X9295 adds the leveler to that pair. Louisville lists the E34 automatic adjusting leveler and the LevelOK stabilizer and leveler for the FE3228. OSHA allows a ladder only on a stable, level surface unless it is secured, and Werner’s four-to-one rule sets the foot one foot out for every four feet of height to the support.

Send us a list with the roof heights and loads, and we will return a quote that pairs each 28 with the leveler it needs.

Werner B7100-2 Series – Type IAA Aerolite Fiberglass Extension Ladder

Roof Brackets, Harnesses and the 28 ft Fiberglass Size

A 28 on a roofing job usually sits beside roof brackets, a ridge hook and an anchor for the harness once the climber is on the shingles. The fiberglass extension ladders section compares every height in this material. The 24 ft fiberglass version covers work that stays under the eave and the 32 ft fiberglass size reaches higher gables, while our 28 ft extension ladders across brands set aluminum against fiberglass.

For the roof anchors, staging and racks other makers build, look through our ladder and truck equipment brands hub.

Werner B7100-2X Series – Type IAA Aerolite Fiberglass Extension Ladder

Quotes on 28 ft Fiberglass Extension Ladders for Roofers and Electricians

Clearing the eave by 3 feet, carrying a roofing load and working beside the mast all point to a rated fiberglass rail at this length, which is how we quote 28 ft fiberglass extension ladders. Our own trucks deliver door to door across Maine, New Hampshire, Vermont, Massachusetts, Rhode Island and Connecticut, so a heavy 28 reaches the yard ready to load.

28 Ft Fiberglass Extension Ladders FAQs

Does a 28 ft fiberglass ladder clear a two-storey roof edge?

Werner's chart averages 27 feet of reach and Louisville lists 27 feet 7 inches at most for the FE3228, and OSHA asks for 3 feet of rail past the landing, so measure the eave against both.

Which of the 28 ft fiberglass extension ladders weighs least?

The Werner Aerolite B7128-2 at 50.1 pounds, against 58 for the Louisville FE3228 and 67 for the Werner D7128-2.

Is there a 28 ft fiberglass ladder with a leveler?

The Werner B7128-2CL and B7128-2X9295 include a leveler system, and Louisville lists the E34 automatic leveler for the FE3228.

How long is the three-section D6228-3 when closed?

Werner lists it at 11 feet 4 inches closed, with a 25 foot working height and a weight of 74.5 pounds.

What does the FE3228 come with for transport?

Louisville lists the Ladder Lash and a side mounted double pulley system among the accessories for the FE3228.

Need help choosing the right ladder or truck equipment?

Talk to the team or send us your list and we will put a quote together.

TOP
Nation Wide Ladder

Nation Wide Ladder