Werner Step Ladders
Werner 5 ft Step Ladders in Type IA Single-Sided, Type IAA Heavy-Duty, Twin and Fixed Podium Versions and More
The middle size between short service ladders and full ceiling ladders, with the 6205, 7305, T6205 and PD6205 compared on weight, rating, standing level and podium reach.
Werner 5 ft step ladders fill the gap between a short service ladder and a full 6 foot model, and the right pick depends on how high you actually need to stand. Nation Wide Ladder quotes four Werner choices at this size, the 6205, the heavy-duty 7305, the T6205 twin and the PD6205 podium, and we help you decide whether 5 feet is enough or a neighbouring size suits better.
- Over 50 years serving contractors
- MA, NH, CT, ME, VT & RI
- Weekly Maine deliveries
Is a Werner 5 ft Size Enough for the Work?
Buyers often land on this size as a compromise, so it is worth checking against the job before ordering, especially for crews who work under a mix of residential and light commercial ceilings. Werner places the highest standing level on a stepladder two steps under the top cap, and OSHA bars standing on the top or top step. Measure the height you need to work at, allow for that rule, and see whether a 5 ft model gets you there without reaching overhead. If it falls short, the next Werner size up is usually the safer buy, and if it leaves plenty of room, a shorter model saves weight on every carry.
Our listings also include a 7 foot model in the 6200 series, the 6207, which suits crews who find 6 feet slightly short and 8 feet too bulky. The heavy-duty Werner 7300 line has no 7 foot size, so its sizes jump from the 7306 to the 7308.
Werner lists each 5 ft model with fiberglass rails built to ANSI A14.5, so the sizing question comes before the material one, and the choice of layout follows once the height is settled.
Our team checks standing height against ceiling and fixture heights, so the Werner 5 ft step ladders on your quote reach the work without stretching.
Werner 5 ft Models by Weight, Rating and Layout
Werner lists the 6205 at 19 pounds and the 7305 at 19.5, so the half pound buys a step up from Type IA at 300 pounds to Type IAA at 375. The 6205 has Werner’s LOCKTOP with a steel plate for magnetic accessories and an impact driver slot, while the 7305 uses an aluminum HolsterTop with eight tool holes. The Werner T6200 twin ladder in its T6205 size weighs 23 pounds and puts 300 pounds on each side, so two installers can share it on either side of a doorway or a run of cabinets, and Werner fits it with a dual HolsterTop holding paint cans, parts trays and tool holes.
The Werner PD6200 podium at this size, the PD6205, weighs 32.5 pounds. Our store lists it with the same reach as a 7 foot stepladder, and Werner titles it with an 11 foot reach height. Its LOCKTOP guardrail wraps the 4X Work Zone, so a painter or electrician can turn on the deck and work around a fixture without climbing down. We do not list the caster PD7300-4C at this height, so crews needing a rolling deck look at the Werner 4 or 6 foot sizes instead.
At our Windham and Worcester showrooms you can open the 6205 and PD6205 side by side and judge the difference in standing room.
Daily Use and Care of Werner 5 ft Ladders
A 5 foot ladder is often the one that moves room to room all day, so wear shows up first on the feet, spreaders and top. Before each shift, look for cracked or bent rails, loose steps, worn feet and damaged spreaders, and take a ladder out of service if anything is off. Werner gives the 7305 a plastic rail shield and slip-resistant foot pads, and the PD6205 has EDGE360 protection at the base, both of which take knocks that would otherwise land on the rails. Store the ladder out of sunlight and away from heat between jobs, and keep labels readable so the rating stays visible to the next user.
OSHA requires a metal spreader or locking device to hold a stepladder fully open, and it bars climbing the rear bracing unless the ladder has steps on both sides, as the T6205 does. Fiberglass meets OSHA’s call for nonconductive side rails near exposed energized equipment, though dirt and moisture can still make a ladder conduct.
Both of our showrooms open Saturday mornings, which suits crews who need to replace a worn 5 ft ladder before Monday.
Werner 5 ft Step Sizes Beside the Neighbouring Heights
A crew that carries a 5 foot ladder usually has a shorter service ladder and a taller ceiling ladder too. The 5 ft step ladders from all the brands we stock sit together for comparison, and the wider Werner step ladder range covers the sizes on either side.
To see racks and shelving from other makers for carrying them, try our ladder and truck equipment brands hub.
Quoting Werner 5 ft Step Ladders for Your Rooms
Four designs at the middle size let a crew trade weight, rating and standing room against each other, and the 6207 sits close by when a little more height is needed. Send us the ceiling heights and climbers, or call 603-434-6911 or 508-754-3030, and we will quote Werner 5 ft step ladders with the Werner store selection and our Werner brand page close by.
Werner 5 Ft Step Ladders FAQs
What Werner 5 ft step models can I order?
Four, the single-sided 6205, the heavy-duty 7305, the T6205 twin and the PD6205 podium.
How much do Werner 5 ft ladders weigh?
Werner lists the 6205 at 19 pounds, the 7305 at 19.5, the T6205 at 23 and the PD6205 at 32.5.
What reach does the Werner PD6205 give?
Werner's title for the PD6205 states an 11 foot reach height, and our store compares it to a 7 foot stepladder.
Is there a Werner 7 ft option near 5 ft?
Yes. The 6200 series includes the 6207 in our listings, between the 6206 and 6208.
How high can I stand on a Werner 5 ft stepladder?
Werner sets the highest standing level two steps under the top cap. OSHA bars standing on the top or top step.
Need help choosing the right Werner equipment?
Talk to the team or send us your list and we will put a quote together.










