Acro range
Acro Guardrail Systems for Open Edges, Flat Roofs, Parapets and Walls, With Warning Lines, Wall Brackets and More
Steel bracket-and-post edge protection that takes standard 2x4 rails, from shingle-interleaving residential brackets to leave-behind flat roof plates, parapet clamps and 42 inch warning line posts.
An open roof edge stops work until it is protected, and Nation Wide Ladder helps crews protect it quickly with Acro guardrail systems, matched by our team to the edges on each job. We supply the 12075 open edge, 12060 flat roof, 12090 parapet and 12045 vertical systems, the 10140 end guard rail, the X and heavy duty warning line sets, and the 48 inch and corner wall scaffold brackets.
- Over 50 years serving contractors
- MA, NH, CT, ME, VT & RI
- Weekly Maine deliveries
Who Relies on Acro Guardrail Systems at a Roof or Open Edge
Residential roofers, commercial roofing contractors, framers and general contractors all face the same OSHA trigger, an unprotected edge 6 feet or more above a lower level. A guardrail answers it for everyone on that section of roof at once, which is the case Acro makes for its systems. Once the rails are up, nobody has to remember to tie off, and Acro says its guardrails need no training or involvement from individual workers and almost no maintenance.
Acro guardrail systems are built as brackets and posts that carry ordinary construction grade 2x4s as the rails, so the steel goes back on the truck while the lumber can be reused or replaced. On a pitched roof the residential brackets nail on and tap off like roof brackets and interleave with the shingles. On flat roofs, parapets, stairwells, skylights and elevator shafts the commercial systems screw, bolt or clamp to the structure. Acro says its guardrail systems can be moved during the roofing process without taking the whole run down.
We have served contractors for over 50 years, and our team will help you lay out which Acro guardrail systems cover the edges on your next job before you order.
Acro Guardrail Systems by Model, From Open Edge Brackets to Parapet Clamps
12075 open edge system. A roof bracket with a guardrail holder and interchangeable post, giving fall protection, a slide guard and a toeboard in one piece. It interleaves with shingles, works on pitches up to 16/12, and Acro rates it for rake edges of any pitch and eave edges under 4/12.
12060 flat roof system. A base plate, post holder and post for horizontal surfaces, weighing 11 pounds. The plate can be screwed, bolted or welded down and left behind when the job ends.
12090 parapet system. Assembles from inside the parapet, fits walls 4 to 24 inches wide and has an adjustable post height. Acro puts the bracket at 19 pounds assembled.
12045 vertical system. Mounts to parapet walls, header beams, floor joists, studs or trusses, in lumber or masonry, with a post holder set 2 inches off the plate to clear caps and drip edges. Acro says its 12055 posts interchange across its guardrail systems.
Warning lines and wall brackets. The 21000 X warning line set has four 42 inch posts and 100 feet of flags, held by screws or 20 pounds of ballast. The Acro 48 inch bracket builds a railed walkway at any height on buildings up to five stories.
Call 603-434-6911 in New Hampshire or 508-754-3030 in Massachusetts with your edge lengths, and we will quote the bracket and post counts for each system.
OSHA Heights, Loads and Post Spacing for Acro Guardrail Systems
OSHA 1926.502 sets the guardrail numbers. The top rail must sit 42 inches above the walking surface, give or take 3 inches, and must not deflect lower than 39 inches under load, while the system must withstand at least 200 pounds without failure. Midrails go midway between the top rail and the surface. On steep roofs, OSHA 1926.501 also calls for toeboards with a guardrail, which is why the 12075 bracket carries a toeboard holder.
Acro lists a maximum post spacing of 8 feet with construction grade lumber across its guardrail systems, and says its open edge system was lab tested to OSHA’s 2011 regulations, including the 200 pound force outward and downward. Its setup advice is practical. Overlap the 2x4s by at least 6 inches inside one of the post brackets so both boards can be nailed, and set the posts so the lumber brackets face inside, away from the open edge. For low-slope roofs, OSHA permits a warning line between 34 and 39 inches high, flagged every 6 feet or less, when combined with another approved method such as safety monitoring.
Our own trucks deliver door to door across New England, so the posts and brackets for a large roof can land on site rather than at your yard.
Acro Guardrail Systems as One Part of a Fall Protection Plan
Edge protection covers the perimeter, but a full roofing setup also needs a safe climb to the eave, footing on the slope and anchors for anyone working outside the rails. Planning those pieces together keeps a crew from guarding an edge they can only reach by a shaky ladder.
To match ladders and harness gear from other makers to your guardrail layout, see the lineup in our ladder and truck equipment brands section.
Get Acro Guardrail Systems Quoted for Your Roof
Send us the roof type, edge lengths and wall widths, and we will price Acro guardrail systems with the posts and warning lines to match. Browse our guardrail and perimeter store, add Acro roof brackets and ridge hooks for footing, or return to the Acro roofing equipment range.
Acro Guardrail Systems FAQs
Which Acro guardrail systems suit a pitched residential roof?
Acro uses its 12070 steep pitch and 12075 open edge systems on residential roofs, with the 12045 vertical and 12060 flat roof systems around holes and edges.
Which Acro guardrail systems suit flat commercial roofs?
Acro points to the 12045 vertical, 12060 flat roof and 12090 parapet systems for commercial roofs, holes and edges.
How high must a guardrail top rail be?
OSHA 1926.502 sets it at 42 inches above the walking surface, plus or minus 3 inches, and the system must withstand at least 200 pounds.
What lumber do Acro guardrail systems use?
They take construction grade 2x4s as rails, with posts no more than 8 feet apart and boards overlapping at least 6 inches inside a post bracket.
How do you secure the Acro 21000 X warning line?
Acro says to weigh each base with 20 pounds or more, such as a cinder block or sand bag, or fasten it to the surface with screws or nails.
Need help choosing the right Acro equipment?
Talk to the team or send us your list and we will put a quote together.










